Sinclair PG20 Manuel d'utilisateur télécharger pdf (Page 4)

In order to adjust the grommet pressure.

- Insert grommet on die #3 as shown in figure 1 below. Make sure bottom of

grommet is up above bottom of top die. No washer is needed for 8mm

grommets. For 12mm grommets, insert washer on die #4 as shown in

figure 2.

- Do a test grommet with the material you are using,

- Slowly loosen #2 die to tighten grommet fit. Use ¼ turns or less at a time.

- Try to spin grommet in material. If grommet is loose, continue to bring die

#2 down until grommet is secure in material and won’t spin.

- When grommet tension is correct, tighten tension nut #1

FIG 1

FIG 2

Grommet

Washer

1 2 3 4 5 6 7 8

Pas de commentaire

Sinclair PG20 Manuel d'utilisateur Page 4